|
Standard
Commercial/Small Business installation
includes those commercial locations
1-2 stories from the ground. Installation includes:
- Mounting the antenna to an outside wall using
HUGHES® standard tri-mast roof/wall mounting brackets, or
on a rooftop using standard Hughes non-penetrating mount, or a ground
pole mount (9 ft. total length). All antennas must be mounted a
minimum of 5 ft. off the ground and out of the reasonable reach of
small children.
Note: Wall mounts must not be mounted to surfaces
or building materials that cannot support the wall mount (for example,
stucco, aluminum siding, or vinyl siding).
- Two exterior cable runs or one dual cable run of
up to 150 feet of standard RG6 coaxial cable with one point of entry
through an exterior wall to an interior wall; and the installation of
a wall jack.
- Connecting ground wire from ground block to NEC
approved bonding point.
- Installing and weather sealing appropriate cable
bushing.
- Conducting a cross-polarization test of the
HughesNetTM system to verify receipt of satellite signal on
the installer laptop. When possible, the installer should use the
customer's PC to confirm receipt of satellite signal.
- Demonstrating to customer that the system is
working by surfing the Web and show customer their site ID and signal
strength.
- Clean-up of any unnecessary materials from
install site.
Non-Standard Installation
- Installations with cable in excess of 150 feet from the
HughesNet dish to the HughesNet receiver and/or requiring additional
drops or hardware are classified as non-standard installs. Locations
that fit this category are typically high-rise buildings and possibly
located in cities such as New York, Chicago, San Francisco, etc.
If you have further questions or believe your business may require a
non-standard installation, please speak with your HughesNet professional
installer for assistance and a quote.
|
