Mount the dish to
an approved structure at least five feet off the ground as
required by FCC regulations, using HUGHES standard roof
and/or wall mounting brackets. Mounted to a one-story
surface
|
Complex/custom installations
that may result in additional fees.
- Make sure you discuss any custom work with your
installer before they begin the job.
|
Install a coaxial cable jack in
the room where the HughesNet System will be located.
|
Custom work including, but not
limited to:
- Moldings or cosmetic hardware to help hide cables
- Non-penetrating roof, pole, or chimney mounts
|
Route two exterior
RG-6 coaxial cables (each up to 100 feet in length) from the
dish into the house, and to the coaxial cable jack. |
Installation of
DIRECTV receivers and cables and/or complex connections to
stereo/audio components. |
Provide and install
the hardware required to properly ground your HughesNet
System. |
Driving distances
of over 35 miles to the job. |
Install the HughesNet HT1000
modem and connect to your PC. |
Removal and/or repair of
previously mounted equipment. (a signed Waiver of Liability
must be included to perform this work). |
Verify receipt of satellite
signal. and perform the necessary tests to insure a
connection to the HUGHES server. |
Mounting to a roof surface that
exceeds one story in height
|
Guide you through
the registration process, and configure your computer to
access the internet. |
Non-penetrating
roof mount, pole mount, or chimney mount. |